Debugging or Troubleshooting? #3

Posted September 13, 2018 by ilee

Help! my run code is red.

image

The Challenge

Is this a debugging or a trouble shooting issue?  Please put your answer and suggest an action to take in a comment.

Winner

This one is typically a debugging issue.   (There is something wrong in the code blocks)

Either a block has an empty socket (an area where it is expecting another block) or there are disconnected blocks in one of the stacks of blocks. Usually the problem was caused by something you changed recently.  Go back to your code and check the recent changes you made.

Comments

Submitted by wkluesner on Sat, 09/22/2018 - 13:15 · Permalink

debugging! - something in the code is incorrect.

Answer

Submitted by philolona on Sat, 09/22/2018 - 13:15 · Permalink

Debugging code is not correct

Answer

Submitted by ccorey on Sat, 09/22/2018 - 13:16 · Permalink

troubleshooting ....check the code to make sure it can be done

Answer

Submitted by kweidle on Sat, 09/22/2018 - 13:16 · Permalink

Debugging

Answer

Submitted by jkdiru on Sat, 09/22/2018 - 13:16 · Permalink

Troubleshooting error because there is a piece of code that is not set up properly.

Answer

Submitted by tracyeefoster on Sat, 09/22/2018 - 13:16 · Permalink

troubleshooting also.

Answer

Submitted by calston4 on Sat, 09/22/2018 - 13:16 · Permalink

You return to the code zone and re-arrange your code.Debugging error. 

Answer

Submitted by ccorey on Sat, 09/22/2018 - 13:16 · Permalink

my bad debugging

Answer

Submitted by skoroneos on Sat, 09/22/2018 - 13:16 · Permalink

Troubleshooting, something needs to happen before run code button turns green.

Answer

Submitted by pwilsonscience on Sat, 09/22/2018 - 13:16 · Permalink

debugging because something in the code is incorrect

Answer

Submitted by ameek on Sat, 09/22/2018 - 13:17 · Permalink

debugging

Answer

Submitted by jesalazar on Sat, 09/22/2018 - 13:18 · Permalink

Code is not correct

Answer